ACOPOWER HY-PLK-100WPX20A Manual - Page 10
Browse online or download pdf Manual for Solar panel ACOPOWER HY-PLK-100WPX20A. ACOPOWER HY-PLK-100WPX20A 17 pages.
Press BATTERY TYPE button and hold for 3 seconds to go into your battery type selection mode, the battery type
you select will be shown on the LCD meter, the default setting is AGM Battery; the controller will automatically me
morize your battery type setting.
Li-ion battery shown in LCD indicates 3-SERIES Li-ion battery shown as below:
-- Lithium Cobalt Oxide LiCoO2 (LCO) battery
-- Lithium Manganese Oxide LiMn2O4 (LMQ) battery
-- Lithium Nickel Manganese Cobalt Oxide LiNiMnCoO2 (NMC) battery
-- Lithium Nickel Cobalt Aluminum Oxide LiNiCoAlo2 (NCA) battery
Remarks: This solar controller is recommended to just work with 3 x series above Li-ion batteries.
LiFePO4 battery shown in LCD indicates Lithium Iron Phosphate battery, LFP battery.
LTO battery shown in LCD indicates Lithium titianate oxidized, Li4Ti5O12 battery.
Caution: Incorrect battery type setting may damage your battery.
When the controller powers on, the unit will run self-qualify mode and automatically show below items on LCD
before going into charging process
Self-test starts, digital meter segments test
Software version test
V
A
ºC
External battery temperature sensor test (if connected)
Indicates the solar panel connected.
After going into charging process, the LCD displays the charging statues as below:
Press VOLT / AMP button in sequence, the LCD will display in turn with
Battery Voltage, Charging Current, Charged capacity (Amp-hour) and Battery
Temperature (if external temperature sensor connected)
Display in sequence-
V
Alternatively Display voltage and FUL when battery is fully charged
V
The VOLT / AMP button can be changed at any time during charging process.
The LCD also can be treated as an independent voltage meter or thermometer.
www.ACOPower.com
Rated voltage and current test
A
A H
HY-PLK-100WPX20A
ºC
4120 Valley Blvd Walnut, CA 91789, USA
Power Your Green Life!
+1-626-737 1140