Caliber 13576 Assembly Instructions Manual - Page 3

Browse online or download pdf Assembly Instructions Manual for Automobile Accessories Caliber 13576. Caliber 13576 10 pages. Sled wheels
Also for Caliber 13576: Assembly Instructions Manual (8 pages)

Print Page

3. Apply one fourth of the grease

(22) to each axle (2) and

assemble a wheel (1), ½"

washer (3), arm (6 and 7), and

locking hex nut (4). Tighten

the axle until snug, then

tighten the axle 1/4 - 1/2 turn

more (approximately 20 ft-lbs)

with a T-55 Torx wrench (a

5/16" or 8mm hex wrench can

be used in a pinch). Repeat

for each of the three remaining

wheels.

4. Slide the assembled arms onto the splined T-Handle (10) and adjust the arm width per Table 2 (on last page of

instructions) and your ski type, or adjust approximately ¼"-½" wider than the ski. Some sleds have spindle bolts

that stick beyond the edge of the ski, for these sleds adjust the arms wider to avoid the bolt (or cut the excess bolt

off). The arm angle can also be adjusted 15° to accommodate tall or short ski loops. Most sleds work best at 15°.

Use two ¼-20 x 1.0" bolts (13), two ¼" washers (16), and two ¼ locking hex nuts (14) to secure each arm in

place using the supplied 5/32" hex wrench (8) (approximately 4 ft-lbs). Do not overtighten. Make sure both arms

are installed at the same angle.

- Page 3 -

Assembled on May 19, 2020

CI05067, rev E