Directed Xpresskit DBALL-NISS08EU Installation Manual - Page 6

Browse online or download pdf Installation Manual for Automobile Accessories Directed Xpresskit DBALL-NISS08EU. Directed Xpresskit DBALL-NISS08EU 10 pages.

Print Page
Platform: DBALL2
Firmware: NISS08EU

Module Reset

A module reset will only erase programming performed in the previous steps. All settings (firmware) and settings flashed
to the module using the web config tool will not be affected.
D2D Installation
If required for your installation, connect the 10-pin, 12-pin &
14-pin harnesses to the module. Press and hold the
programming button, then connect the 4-pin D2D harness.
OR
1
W2W Installation
If required for your installation, connect the 10-pin & 12-pin
harnesses to the module. Press and hold the programming
button, then connect the 14-pin harness to the module.
Wait 3 seconds until the LED turns ON solid orange then release the
2
programming button. The LED then turns ON solid red.

Hard Reset

Warning Against Executing a Hard Reset!
A hard reset will revert the flashed firmware back to its default settings. Depending on the installation, some settings (such
as RFTD and D2D options) may have to be reconfigured. See the Feature & Option List section of this guide.
D2D Installation
If required for your installation, connect the 10-pin, 12-pin &
14-pin harnesses to the module. Press and hold the
programming button, then connect the 4-pin D2D harness.
1
OR
W2W Installation
If required for your installation, connect the 10-pin & 12-pin
harnesses to the module. Press and hold the programming
button, then connect the 14-pin harness to the module.
Wait 3 seconds until the LED turns ON solid orange, and wait 10 more seconds
2
until the LED starts to flash orange and red.
3
Release the programming button. The LED turns ON solid red.
rd
3
th
5
st
2
1
th
4
st
2
1
&
Solid
rd
3
th
5
st
2
1
th
4
st
2
1
© 2020 Directed. All rights reserved.
Rev.: 20200502
Page 6
nd
th
4
nd
rd
3
&
Release
Solid
nd
th
4
nd
rd
3
&
Solid
Flashes
&
Release
Solid