Directed Xpresskit DBALL2 Installation Manual - Page 6

Browse online or download pdf Installation Manual for Automobile Accessories Directed Xpresskit DBALL2. Directed Xpresskit DBALL2 10 pages. Ford5 remote start ready (rsr) installation
Also for Directed Xpresskit DBALL2: Installation Manual (12 pages), Installation Manual (19 pages), Installation Manual (18 pages), Manual (14 pages), Installation Manual (13 pages), Installation Manual (14 pages), Installation Manual (19 pages), Installation Manual (16 pages), Installation Manual (20 pages), Installation Manual (15 pages), Installation And Quick Reference Manual (16 pages), Installation Manual (18 pages), Installation Manual (16 pages), Installation Manual (18 pages), Installation Manual (16 pages), Manual (19 pages), Installation Manual (11 pages)

Print Page
Directed Xpresskit DBALL2 Installation Manual
Platform: DBALL2
Firmware: REN11

Module Reset

A module reset will erase the module programming only (bypass, convenience and vehicle detection). All the settings
configured on the module using the web config tool will remain untouched.
D2D Installation
If required for your installation, connect the 10-pin, 12-pin &
14-pin harnesses to the module. Press and hold the
programming button, then connect the 4-pin D2D harness.
OR
1
W2W Installation
If required for your installation, connect the 10-pin & 12-pin
harnesses to the module. Press and hold the programming
button, then connect the 14-pin harness to the module.
Wait 3 seconds until the LED turns ON solid orange then release the
2
programming button. The LED then turns ON solid red.

Hard Reset

Warning Against Executing a Hard Reset!
A hard reset will erase all the data stored in the DBALL and will change all the settings configured on the module to its
default values. After a hard reset, you may have to reconfigure your DBALL if your installation requires specific options,
not part of the default configuration. See the Feature & Option List section of this guide.
D2D Installation
If required for your installation, connect the 10-pin, 12-pin &
14-pin harnesses to the module. Press and hold the
programming button, then connect the 4-pin D2D harness.
OR
1
W2W Installation
If required for your installation, connect the 10-pin & 12-pin
harnesses to the module. Press and hold the programming
button, then connect the 14-pin harness to the module.
Wait 3 seconds until the LED turns ON solid orange, and wait 10 more seconds
2
until the LED starts to flash orange and red.
3
Release the programming button. The LED turns ON solid red.
rd
3
th
5
st
2
1
th
4
st
1
2
&
Solid
rd
3
th
5
st
2
1
th
4
st
1
2
© 2022 Directed. All rights reserved.
Rev.: 20230129
Page 6
nd
th
4
nd
rd
3
&
Release
Solid
nd
th
4
nd
rd
3
&
Solid
Flashes
&
Release
Solid