Clarke CIR450 Operating & Maintenance Instructions - Page 8
Browse online or download pdf Operating & Maintenance Instructions for Power Tool Clarke CIR450. Clarke CIR450 16 pages. Professional cordless impact wrench
Print Page
BATTERY CHARGING
1. The new battery pack will require
charging before use.
2. Squeeze the battery release buttons on
either side of the battery pack and pull
gently down to disengage the battery
pack from the machine as in Fig 1.
3. Insert the battery pack into the battery
charger, as shown in Fig 2, noting that it
will only fit one way.
4. Plug the charger into a 230v (mains)
power supply and switch ON.
• The green POWER ON light will
illuminate with the RED charging light
flashing and charging will begin.
• If charging does not take place,
ensure all connections are clean
and free of grease etc.
• If the red charging light will not stay
on for more than a few moments, the battery
pack is likely to be defective and it must be
replaced with a new one.
• When the RED charging light goes out
after about 1/2 hour, and the GREEN
light remains on, the battery pack can
be considered charged and be
removed. The charging time will be
dependant upon the initial state of the
batteries.
• When charging a new battery pack it
may initially not accept full charge. This
is common & does not indicate a fault.
It can be recharged fully after it has
been discharged a couple of times.
5. After charging, switch off and unplug the
charger from the power supply.
6. Remove the battery pack from the
charger and slide it back into the
machine until it clips into place. The
battery pack should slide in easily.
8
FIG 1
FIG 2