Clarke cp185 Operating & Maintenance Instructions - Page 10

Browse online or download pdf Operating & Maintenance Instructions for Power Tool Clarke cp185. Clarke cp185 16 pages. Sander/polisher

Print Page

MAINTENANCE

Before commencing any maintenance procedures, always ensure the

sander/polisher is isolated from the electrical supply by switching off and

removing the plug from the power socket.

BEFORE USE

1. Always inspect the tool before use and ensure it is in top condition.

2. Ensure all fixing screws remain tight to ensure the tool is in safe working

condition.

3. Inspect the power cable to ensure it is sound and free from cracks or bare

wires etc.

CLEANING

1. Ensure all air ventilation slots are clear, (Use compressed air to clean the

tool if possible. Always wear protective goggles when cleaning with

compressed air).

2. Clean the exterior of the tool with a soft cleaning cloth. Never use any

chemicals or harsh abrasives. Avoid using solvents when cleaning plastic

parts, which may be susceptible to damage from various types of

commercial solvents.

GENERAL MAINTENANCE

1. Occasionally remove and inspect

the motor brushes and replace if

necessary.

• When removing brushes, note which

way round they are. The brushes

must be returned exactly as they

are removed, DO NOT swap over

positions etc.

2. Never allow the brushes to wear

more than two thirds of their original

length, (new brushes are

approximately 13 mm long), fit new brushes when or before they are worn

down to 5 mm.

• All bearings etc, in this tool are lubricated with a sufficient amount of high

grade lubricant for the tools lifetime under normal operating conditions,

therefore no further lubrication is necessary.

• Refer to your CLARKE dealer if internal maintenance is required.

Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]