Clarke CPR2 Operating & Maintenance Instructions - Page 7

Browse online or download pdf Operating & Maintenance Instructions for Power Tool Clarke CPR2. Clarke CPR2 13 pages. Oil free riveter

Print Page

Insert the rivet into the workpiece to be secured, pressing firmly depress the

trigger. The riveter will 'fire', breaking off the mandril, allowing the riveter to be

removed from the workpiece and re-loaded. Spent mandrills will be ejected

from the rear of the riveter.

To change the nosepiece, unscrew and remove the installed nosepiece, a

slight spring resistance will be felt.

Choose the nosepiece to be installed, push firmly against spring resistance into

the head (item 2), screw home and tighten with the wrench supplied.

DISCONNECTING THE AIR SUPPLY

Do not disconnect the air supply hose until the air supply has been shut down

and the compressed air released.

1. Refer to the compressor instruction manual for the procedure to shut down

and release the compressed air.

2. Once the pressure has been released, disconnect the air supply hose from

the air tool.

Store the tool safely in its box in a dry, secure environment.

WARNING: MAKE SURE THAT THE TOOL IS DISCONNECTED FROM THE AIR

SUPPLY BEFORE STARTING ANY CLEANING, OR MAINTENANCE

PROCEDURES.

DAILY

1. Before use, drain water from the compressed air supply.

2. Pour a few drops of CLARKE airline oil, into the air inlet. This should be

carried out regardless of whether or not an in-line mini oiler is used. If an

inline mini oiler is not used, this procedure should be repeated after every

two to three hours of use.

CLEANING

1. Keep the body of the tool clean and free from debris. Grit or gum deposits

in the tool may reduce efficiency.

If the riveting action becomes erratic or the riveter operates but fails to form a

rivet successfully, it is possible that the jaw housing assembly (items 3 - 8)has

worked itself loose, and requires adjusting. Should this occur, proceed as

follows:

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]