Clarke CPSB200 Operation & Maintenance Instructions Manual - Page 9

Browse online or download pdf Operation & Maintenance Instructions Manual for Power Tool Clarke CPSB200. Clarke CPSB200 20 pages. Pressurised sandblaster

Print Page

LOADING THE ABRASIVE

• To prevent clogging, ensure that the abrasive you use is dry.

• While you may re-use abrasive, remember that abrasive grit/

material does wear out. After use, abrasive becomes smoother and

rounder, thus reducing its effectiveness.

NOTE: Re-using abrasive may also cause clogging due to fine debris

contained in the mixture from prior use.

Close the air supply valve by

turning it to the closed position,

see Fig 7.

2. Press the trigger to release any

pressure from the tank.

• Make sure the pressure gauge

reads "0".

3. Remove the filler cap.

Using the sieve and funnel

supplied, pour the selected

abrasive medium into the tank,

see Fig 8.

• Do not fill the tank more than

full.

• If humidity in your region is 90%

or more, only fill the tank

and check the water trap more

frequently.

5. Replace the filler cap ensuring the

0-ring is in place.

NOTE: Place your air compressor in another room if possible to prevent

damage from the intake of abrasive dust laden air.

TO START BLASTING

NOTE: Start with all valves in the closed position. Following the instructions

below will help prevent clogging in the delivery hose, outlet

manifold and the trigger.

1. Connect the compressor to the inlet connector shown in Fig 7.

full

Fig 7

Fig 8