Directed Directechs DB3 Installation Manual - Page 5

Print Page

Pre-installation and application warnings

Firmware notes: This section highlights important information for this specific firmware and will assist in

pricing accordingly, as well as bringing awareness to any operational or vehicle limitations.

T-Harness

compatible

Warning! Door Lock function may not operate on older vehicle that do not have the OnStar feature (active or not).

Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic

connector.

Refer to the "Vehicle connections" following the installation diagram.

Warning! Make sure the 2nd accesory is powered up on the Chevrolet Monte Carlo and Impala. This NEEDS to be done

otherwise the vehicle will not crank the starter.

Rear Hatch or Trunk Release Input: On vehicle with a motorized rear hatch, this input will release the hatch. See

programming options to change its operations.

The heated seat feature must be enabled. Refer to "Feature Programming" for more information.

General notes: This section highlights important information for this specific firmware.

Tach wire is an optional connection required on some remote starters, which do not support a tach signal in D2D.

[1]

ONLY required when not available through data. For more specific information about the connection, refer to directechs.

[2]

com.

403.GM5 4.17 2005 Chevrolet Malibu Classic

Keys required for

programming

operation