Clarke PRO235 Operating & Maintenance Instructions - Page 5
Browse online or download pdf Operating & Maintenance Instructions for Power Tool Clarke PRO235. Clarke PRO235 9 pages. 1/4” drive digital torque wrench
Print Page
PREPARATION FOR USE
FITTING THE BATTERIES
1. Unscrew the battery cap.
2. Install batteries (2 x CR2032 as supplied) with their marked faces outwards,
and screw the cap back on.
• If the batteries are in poor condition the
operation and new ones should be fitted.
• Typical life of the batteries is 60 hours continuous use.
SWITCHING ON & OFF
1. Press the
• The LCD panel will display all characters and after 2 seconds the display
will show 0.00.
• The wrench will be in
actual torque detected.
3. To manually turn the wrench off, press and release the
• If you do not use the wrench for 3-4 minutes it will turn off automatically.
4. Never turn the wrench off while force is applied.
DISPLAY LIGHTING
1. Press the button
2. Press again to turn the lighting off.
HOW TO SET 'TRACK' OR 'PEAK'
1. Press and release the
• The display can alternate between peak and track (track is the default
mode and is not displayed.
HOW TO SELECT THE UNIT OF MEASUREMENT'
1. Press and hold the
• The display will scroll quickly through the available units of measurement.
(N.m, lbs-in, lbf.ft and Kgf.m).
2. Release the
Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]
button to turn the wrench on.
'TRACK'
for the display lighting to come on.
M/u
button to exit peak, if track is preferred.
M/u
button for 2 secs.
M/u
button when your required unit is shown.
icon will flash during
mode, i.e., it will measure and display the
5
button.