Clarke Strong-arm AHP 16 Operation & Maintenance Instructions Manual - Page 7

Browse online or download pdf Operation & Maintenance Instructions Manual for Power Tool Clarke Strong-arm AHP 16. Clarke Strong-arm AHP 16 13 pages. 15 tonne hydraulic press

Print Page

MAINTENANCE

A visual inspection must be made before each use of the press, checking for

leaking hydraulic fluid, and damaged, loose or missing parts.

Owners and/or users should be aware that repair of this equipment may

require specialised knowledge and facilities. It is recommended that a

thorough annual inspection of the press be made and that any defective

parts, decals or warning labels be replaced with genuine Clarke parts.

Any press which appears to be damaged in any way, is found to be badly

worn, or operates abnormally SHOULD BE REMOVED FROM SERVICE until the

necessary repairs are made.

PERIODICALLY

• Check the press frame to make sure all bolts are tight and inspect for

cracked welds, bent, loose or missing parts.

• Check the hydraulic connections for leaks. Replace or properly repair any

damaged or leaking hydraulic components before using.

EVERY 6 MONTHS

• Check the hydraulic pump oil level, by removing the plug from the front of

the unit. Oil should be level with the bottom of the hole. If necessary top up

with CLARKE Hydraulic Oil, Part No. 3050830 only. This operation is carried out

with the ram fully retracted.

EVERY 2 YEARS

• Replace the hydraulic oil. This operation requires the dismantling of the

hydraulic system, for which you should consult your CLARKE dealer.

• If any rust is apparent it must be removed completely and reinspected.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]