Zanussi ZI 5233 Instruction Booklet - Page 5
Browse online or download pdf Instruction Booklet for Refrigerator Zanussi ZI 5233. Zanussi ZI 5233 9 pages.
Print Page
D
D615
with the appliance. Snap vent grille (C) and hinge
cover (D) into position.
D616
B B
D013
H
D094
the runners to the kitchen unit door using
3.5x16 mm screws.
Fig. 4
Open the door and
push the
appliance against
the side of the
kitchen unit
opposite to that
of appliance
hinges.
Fasten the
C
appliance with 4
screws provided
in the kit included
Fig. 5
Press in the joint
covers between
the appliance and
the kitchen unit.
Fig. 6
Apply covers (B)
on joint cover lugs
and into hinge
holes.
Fig. 7
Position the
runners (H) at the
top and bottom of
the inside of the
kitchen unit as
shown in Fig. 7
and mark the
position of the
external holes.
After preparing
the holes, screw
8mm
PR34
PR35
of the kitchen unit door, if necessary, use the
clearance size of the slotted holes.
At the end of the procedure, check that the doors of
the appliance and the kitchen unit open properly.
Inner door reversal
Using a screwdriver release bracket (1) by pressing
on the internal spring (Fig. 10) and withdraw it
from its seat together with the door;
remove plug (2) and fit it in the hole left open on the
opposite side;
180°
2
PR140
To ensure correct storage of food, the door is fitted
with a simple spring device which holds it in the
open position until it is properly closed.
Fig. 8
Open both the
appliance door
and that of the
kitchen unit to
approx. 90 .
Place the little
plates over the
runners. Hold the
doors of the
appliance and the
unit together and
mark the holes.
Fig. 9
Remove the little
plates and make
the holes with a
diam. of 2 mm.
Replace the little
plates over the
runners and
screw in the
screws provided
(3.5x16 mm).
For the alignment
Fig. 10
turn the door
through 180 ,
remove the
bracket (1) and
refit it on the
opposite side.
Refit the door and
1
insert the top pin
and bottom
bracket (1),
pushing it into
place.
33