Zanussi ZK 24 FX Instruction Booklet - Page 17

Browse online or download pdf Instruction Booklet for Refrigerator Zanussi ZK 24 FX. Zanussi ZK 24 FX 19 pages. Zanussi instruction booklet fridge freezer zk 24 fx

Installation Requirements

To ensure correct operation of this appliance, it must not be located where the temperatures will fall below 16
o
(61
F) or rise above 32
For correct operation this appliance must be :
In a dry atmosphere
Out of direct sunlight
Away from extreme temperature (not next to a
cooker or other source of heat).
The appliance is heavy when fully loaded, and
must be stood on a strong floor.
Ventilation
Allow a 25mm (1 inch) space behind and above the
appliance for ventilation.
In a recessed installation, allow an extra 10 - 15mm
(½ inch) on each side for ease of installation. If the
side of the unit is to be placed against a wall, allow
43mm (1¾ inch) space for proper door opening.

Levelling

The appliance has four castors. The two castors at
the front of the appliance should be adjusted to
ensure that the cabinet is level.
To adjust the front castors:
1.
Open both doors.
2.
Remove the base grille by pulling it straight out.
3.
Adjust the casters by turning the adjusting bolt
with a spanner until the refrigerator is level and
stable.
If the freezer door is higher than the refrigerator
door, raise the right corner and/or lower the left
corner until the doors align across the top of the
cabinet.
If the refrigerator door is higher than the freezer
door, raise the left corner and/or lower the right
corner until the doors align cross the top of the
cabinet.
The rear castors are not adjustable.
4.
Check both doors to ensure that the seals touch
the cabinet on all sides.
5.
Replace the bottom grille by lining up the retain-
ers with the holes and pushing the grille straight
on.
o
o
C (90
F).
Avoid the following locations:
Unheated kitchen
Outhouse
Conservatory
Garage
Turn the bolt clockwise
to raise
Turn the bolt
anti-clockwise to lower
17
o
C