Zanussi ZK 24/9 AGO Instruction Booklet - Page 5
Browse online or download pdf Instruction Booklet for Refrigerator Zanussi ZK 24/9 AGO. Zanussi ZK 24/9 AGO 7 pages.
Also for Zanussi ZK 24/9 AGO: Instruction Booklet (13 pages)
Print Page
If the freezer has already been working for some
time, turn the ambient knob to the "S" symbol at
least 12 hours before introducing the food into the
freezer in order to ensure better freezing results.
Place the food to be frozen on the upper
compartment.
Do not put carbonated liquids (fizzy drinks, etc.) in
the freezing compartment as they may burst.
Water ices, if consumed immediately after removal
from the freezing compartment, can possibly cause
the skin to be freeze burnt.
Remember that, once thawed, frozen food deterio-
rates rapidly.
When first starting-up or after a period out of use,
before putting the products in the compartment let
the appliance run at least two hours on the coldest
setting, then turn the thermostat knob to the normal
operating position.
To obtain the best performance from this appliance,
you should:
if large quantities of food are to be stored, remove all
drawers and baskets from appliance and place food
on cooling shelves.
Pay careful attention not to exceed load limit stated
on the side of the upper section (where applicable).
16
Deep-frozen or frozen food, prior to being used, can
be thawed in the refrigerator compartment or at
room temperature, depending on the time available
for this operation.
Small pieces may even be cooked still frozen,
directly from the freezer: in this case, cooking will
take longer.
This appliance is equipped with one or more trays
for the production of ice-cubes. Fill these trays with
water, then put them in the freezer compartment.
To obtain the best performance:
•
do not store warm food or evaporating liquids in
the refrigerator;
•
do cover or wrap the food, particularly if it has a
strong flavour.
•
Position food so that air can circulate freely round
it.
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc.
For safety reasons, minimum ventilation must be as
shown in Fig.
Appliance positioned under overhanging kitchen wall
units (see Fig. A).
Appliance positioned without overhanging kitchen
wall units (see Fig. B).
Two adjustable feet at the cabinet base allow
accurate levelling of the appliance.
Slacken the screws and insert the spacer under the
screw head, then re-tighten the screws.
Before plugging in, ensure that the voltage and
frequency shown on the serial number plate
correspond to your domestic power supply. Voltage
can vary by ±6% of the rated voltage.
For operation with different voltages, a suitably sized
auto-transformer must be used.
The power supply cable plug is provided with a
contact for this purpose.
If the domestic power supply socket is not earthed,
connect the appliance to a separate earth in
compliance with current regulations, consulting a
specialist technician.
This appliance complies with the following
E.E.C. Directives:
of 2/6/87 relative to radio interference
suppression.
of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.
It must be possible to disconnect the appliance from
the mains power supply; the plug must therefore be
easily accessible after installation.
A
B
NP008
D594
21