Zanussi ZRG717CW User Manual - Page 9

Browse online or download pdf User Manual for Refrigerator Zanussi ZRG717CW. Zanussi ZRG717CW 12 pages. Zanussi refrigerator user manual
Also for Zanussi ZRG717CW: Instruction Book (16 pages)

Print Page

Location

The appliance should be installed well away from sources

of heat such as radiators, boilers, direct sunlight etc. En-

sure that air can circulate freely around the back of the

cabinet. To ensure best performance, if the appliance is

positioned below an overhanging wall unit, the minimum

distance between the top of the cabinet and the wall unit

must be at least 100 mm . Ideally, however, the appliance

should not be positioned below overhanging wall units.

Accurate levelling is ensured by one or more adjustable

feet at the base of the cabinet.

If the cabinet is placed in a corner and the side with the

hinges facing the wall, the distance between the wall and

the cabinet must be at least 10 mm to allow the door to

open enough so that the shelves can be removed.

Door reversibility

Important! To carry out the following operations, we

suggest that this be made with another person that will

keep a firm hold on the doors of the appliance during the

operations.

1. Remove the plug from

the power socket.

2. Tilt back the appliance

carefully so that the com-

pressor cannot touch the

floor.

3. Unscrew both adjustable

feet.

4. Unscrew the screws of

the door bottom hinge.

1) If foreseen

Do a final check to make sure that:

• All screws are tightened.

• The door opens and closes correctly.

5. Take off the appliance

door by pulling it slightly

downwards.

6. Unscrew the top door

hinge pin of the appliance

then screw it back on the

other side.

7. Fit the appliance door on

the upper door hinge pin.

Warning!

It must be possible to dis-

connect the appliance from

the mains power supply; the

plug must therefore be easi-

ly accessible after installa-

tion.

To change the opening direction of the door, do these

steps:

8. Remove the lower hinge.

Put over the pin in the di-

rection of the arrow.

9. Unscrew and install the

screw on the opposite side.

10. Install the lower hinge

on the opposite side leav-

ing the position of the door

unchanged.

11. Screw in the one screw

in the place set free on the

other side as well as the ad-

justable feet (2 pieces).

If the ambient temperature is cold (i.e. in Winter), the

gasket may not fit perfectly to the cabinet. In that case,

wait for the natural fitting of the gasket.

12. Remove and install the

handle

on the opposite

side.

13. Reposition, level the

appliance, wait for at least

four hours and then con-

nect it to the power socket.