Zanussi FM 15 Instructions For The Use And Care - Page 11
Browse online or download pdf Instructions For The Use And Care for Oven Zanussi FM 15. Zanussi FM 15 20 pages. Built-in double oven
Also for Zanussi FM 15: Use And Care Instructions Manual (20 pages), Instructions For Use And Care Manual (20 pages)
The digital electric programmer
The electric programmer has the purpose
of turning on the cooker automatically at
the preset time and to turn it off
automatically when the cooking time
is up.
Furthermore, it also features an electric
clock, showing the hour of the day and a
minute minder with electric bell.
Operation of the electric
programmer
Fig. 6 shows the controls of the electric
programmer.
By means of knobs 1, 2 and 3, all
necessary adjustments can be carried out
i.e.:
Knob 1
By turning this knob clockwise, you can
reset the digital clock to the correct time
(for instance upon installation or
following a power failure, or when the
clock is fast or slow, etc.).
Knob 2
By turning it clockwise, this knob will
set the following controls on dial 4
(Fig. 6):
the required cooking time (up to 210
mins.);
the «crossed bell» $X symbol to
interrupt the sound signal;
the «open hand»
ll symbol permits
manual operation of the oven.
Knob 3
By pressing it in and turning it either
clockwise or anticlockwise, this knob
allows you to set on dial 5 (Fig. 6) the
cooking start time.
When resetting the clock make sure that
the time shown by dial 5 coincides with
the time shown by the clock itself.
Attention
The cooking of dishes with the oven
preset for «manual operation» is possible
only if the time of the day shown by the
electric clock is synchronized with the
time shown on dial «5».
Therefore, when the oven is started for
the first time, during time corrections
due to the clock being fast or slow, or
whenever a fully automatic cooking
process is interrupted, it will be
necessary to check and - if need be
- restore such synchronization.
The programmable electric clock is
synchronized when it is possible to turn
on the oven inner light.
Manual operation of the upper
oven
The oven may also be operated manually,
i.e. with the programing device not
actuated. In this case, turn knob 2 of the
programming device clockwise until the
«open hand»
symbol coincides with
the index of dial 4.
Semiautomatic operation of the upper
oven
This oven makes it possible to either
finish or start cooking automatically,
both in the oven itself and with the grill.
1st instance:
manual cooking start
- programmed, i.e.
automatic
cooking stop.
Place the food to be cooked into the
oven;
Turn knob 2 clockwise, and set on dial 4
the number of minutes corresponding to
the required cooking end;
Turn the oven knob to the required
temperature setting.