Zanussi AquaCycle 1000 Instruction Booklet - Page 6

Browse online or download pdf Instruction Booklet for Washer Zanussi AquaCycle 1000. Zanussi AquaCycle 1000 20 pages. Washing machine f1000

Print Page

The inlet hose must not be lengthened. If they are

too short and you do not wish to move the tap, you

will have to purchase new, longer hose specially

designed for this type of use.

The inlet hose is provided with a water stop device,

which protects against damage caused by water

leaks in the hose which could develop due to natural

ageing of the hose. This fault is shown by a red

sector in the window "A". Should this occur, turn the

water tap off and refer to your Service Centre to

replace the hose.

Important !

Before connecting up the machine to new pipework

or to pipework that has not been used for some time,

run off a reasonable amount of water to flush out any

debris that may have collected in the pipes.

Water drainage

The end of the drain hose can be positioned in four

ways:

Hooked over the edge of a sink using the plastic

hose guide supplied with the machine. In this

case, make sure the end cannot come unhooked

when the machine is emptying.

This could be done by tying it to the tap with a piece

of string or attaching it to the wall.

In a sink drain pipe branch. This branch must be

above the trap so that the bend is at least 60 cm

above the ground.

Directly into a drain pipe at a height of not less

than 60 cm and not more than 90 cm.

The end of the drain hose must always be

ventilated, i.e. the inside diameter of the drain pipe

must be larger than the outside diameter of the drain

hose.

Floor drain: the washing machine should be

installed where a floor drain or hole is located

(depending on plumbing regulations). A floor drain is

required to drain away water which may overflow

from the washing machine due to a hose leak or

malfunction.

The drain hose must not be kinked. Run it along the

floor; only the part near the drainage point must be

raised.

The drain hose may be extended to a maximum of 4

metres. An additional drain hose and joining piece

is available from your local Service Centre.

Electrical connection

Plug the washing machine into a properly earthed 3

pin power point.

DO NOT USE AN EXTENSION CORD.

CAUTION !

If the appliance is supplied from a cord extension

set or an electrical portable outlet device, the

cord extension set or electrical portable outlet

device must be positioned so that it is not

subject to splashing or ingress of moisture.

The manufacturer declines any responsibility

for damage or injury through failure to comply

with the above safety precaution.

IMPORTANT!

If the electrical cord of this appliance is

damaged, it must be replaced by the

Manufacturer, Authorised Service Agent or

similarly qualified person in order to avoid a

hazard.