Zanussi FJE 904 Instruction Booklet - Page 10
Browse online or download pdf Instruction Booklet for Washer Zanussi FJE 904. Zanussi FJE 904 23 pages. Washing machine fje 904 - fje 1204g
Print Page132992150•FJE904•gb.qxd
02/04/03
The zero will reappear when you switch the
washing machine on, unless the previous
programme has been erased by means of the
SKIP/RESET button.
Important!
The first time you use the washing machine,
when you switch it on, it may display a blinking zero and
give an audible warning signal. This is due to the fact
that the washing machine has performed a washing
cycle during the manufacturer's inspection tests, and
this cycle has not been erased after its completion.
• Delay start, a time value indicated in hours and
selected by means of the relevant button.
The delay time is displayed for 3 seconds, then the
duration of the selected programme reappears.
After you have pressed the START/PAUSE button,
the countdown begins, and the delay time value
decreases by one unit every hour.
You can delay the start of the selected programme
by up to 24 hours in one hour intervals.
• An incorrect option selection has been made: this
is indicated by the message Err when a function
incompatible with the current programme is selected.
The incorrect selection is also indicated by an
audible warning signal.
• An alarm code indicates a fault in the machine
operation (see the relevant chapter on page 21).
12:27
Pagina 10
(Nero/Process Black pellicola)
9 START/PAUSE button
This button has three functions:
• Start: after you have selected the desired
• Pause: when you press this button again, the
Important! You must set the washing machine to
PAUSE before you make any change in the
programme in progress.
• Draining of water and spinning after the execution
10 SKIP/RESET button
At the end of a programme, you must press this
button once or repeatedly, in order to clear the
contents of the memory (the display will show three
blinking dashes); otherwise, the next time you switch
the washing machine on, the blinking zero will
reappear and the audible warning signals relevant to
the end of the previous cycle will be given.
You can also press the RESET button to exclude
one or several phases of the programme which is
running, as indicated below.
- set the washing machine to PAUSE by pressing the
- press the RESET button once or several times, until
10
programme and options, press this button to start
the washing machine. The light above the button
will stop flashing and remain lit.
If you have selected a delay time by means of
button 11, the countdown will begin and will be
shown on the display.
programme in progress is interrupted. The light
above the button will start flashing. To restart the
programme, press the button again.
When you PAUSE the cycle, the DOOR LOCKED
light goes out, and it becomes possible to open the
door, provided
• the washing machine is not in the heating phase;
• the level of the water is not high;
• the drum is not turning.
of programmes with the RINSE HOLD
START/PAUSE button (the relevant light will flash);
the required phase(s) is(are) cancelled (the light next
to the symbol of the phase(s) will go out).
option.