Zanussi ZWS 588 User Manual - Page 19

Browse online or download pdf User Manual for Washer Zanussi ZWS 588. Zanussi ZWS 588 24 pages. Front-loading washing machine

Print Page

• Unscrew the hose from the machine. Keep a rag

nearby because some water may flow.

• Clean the filter in the valve with a stiff brush or with

the piece of cloth.

35°

• Screw the hose back to the machine and make sure

the connection is tight.

• Turn on the water tap.

Frost precaution

If the machine is exposed to temperatures below 0°C,

certain precautions should be taken.

• Turn off the water tap.

• Unscrew the inlet hose.

Installation

Unpacking

All transit bolts and packing must be removed before us-

ing the appliance.

You are advised to keep all transit devices so that they

can be refitted if the machine ever has to be transported

again.

• Place the end of the inlet hose in a bowl placed on the

floor, open the emergency emptying cap of the filter

and let water drain out.

• Refit the emergency emptying cap into the filter and

screw the water inlet hose back.

• When you intend to start the machine up again, make

sure that the room temperature is above 0°C.

Emergency emptying out

If the water is not discharged, proceed as follows to empty

out the machine:

• pull out the plug from the power socket;

• close the water tap;

• if necessary, wait until the water has cooled down;

• open the pump door;

• place a bowl on the floor. Remove the emergency emp-

tying cap from the filter. The water should drain by

gravity into the bowl. When the bowl is full, refit the

45°

emergency emptying cap into the filter. Empty the bowl.

Repeat the procedure until water stops flowing out;

• clean the pump if necessary as previously described;

• screw the pump cover again and close the door.

Important! Every time you drain the water through the

emergency emptying hose you must pour 2 litres of water

into the main wash compartment of the detergent drawer

and then run the drain programme. This will activate the

ECO Valve device avoiding that part of the detergent

remains unused at next washing.

After removing all the

packaging, carefully lay

machine on it's back to re-

move the polystyrene base

from the bottom.

Remove the power supply

cable and the hoses from

the hose holders on the

rear of the appliance.