Zanussi DW 6614 Instruction Booklet - Page 23

Browse online or download pdf Instruction Booklet for Dishwasher Zanussi DW 6614. Zanussi DW 6614 24 pages. Dishwasher dw 6614

Print Page

Adjusting the worktop

You can move the worktop forward or backward by

25 mm in order to align the machine with other

kitchen units.

Simply unscrew the two rear retaining screws,

move the top to the required position and then

retighten the screws.

(kitchen worktop or sink)

By removing the machine's worktop, you can install

it under a close fitting sink unit or a pre-existing

top, providing the dimensions of the recess

correspond to those shown in the picture.

Proceed as follows:

Remove the machine's worktop by unscrewing the

two rear retaining screws, pull from the front and

slide out the rear slots, lifting the worktop.

Insert the machine after adjusting height and

levelling with the adjustable feet. When inserting

the machine, ensure that the water inlet and drain

hoses are not kinked or squashed.

Fitting a decor panel on the door

The door of this machine has frames for fitting a

plastic laminate decor panel in the colour required

to match the dishwasher with the rest of the kitchen

furniture. If you wish to do this you must provide

the panel yourself, that must have the following

dimensions.

Width:

588 mm

Height:

586 mm

Max thickness:

4 mm

To fit the panel

Take the door frame off after removing the retaining

screws around the edge.

Position the panel, refit the frame and tighten the

retaining screws around the edge.

Note:

The panel should be fitted before positioning

the machine.

IN26

IN05

AP01

PFI01GB