Directed CHRYSLER5 Installation Manual - Page 6

Browse online or download pdf Installation Manual for Automobile Electronics Directed CHRYSLER5. Directed CHRYSLER5 20 pages.

Print Page

Wiring connections

The wiring connections listed below are specific to this firmware.

Main power harness (H1), 12-pin thick gauge connector

Conn./Pin

Color

H1/1

White

H1/2

White/Brown

H1/3

Brown/Red

H1/4

Yellow/Red

H1/5

Orange/Red

H1/6

Yellow

H1/7

White

H1/8

White/Brown

H1/9

Black

H1/10

Red

H1/11

Orange/Yellow

H1/12

Brown

Auxiliary output harness (H2), 16-pin black connector

Conn./Pin

Color

H2/1

Violet/Brown

H2/2

Yellow/Black

H2/3

Orange/Black

H2/4

Tan

H2/5

Tan/Black

H2/6

Light Green

H2/7

Orange/Green

H2/8

Orange/Brown

H2/9

Violet/Green

H2/10

Green/Black

H2/11

White/Violet

H2/12

White/Red

H2/13

Lt. Blue/Black

H2/14

Green/Red

H2/15

N/A

H2/16

Violet/Yellow

If these outputs are not used by the firmware, they can be configured by the installer when the module is flashed.

If these outputs are not used by the firmware, they can be configured by the installer when the module is flashed. Note that they are low current and a relay

may be necessary.

Description

Relay 3 COM – No Connection

Relay 3 N.O. – No Connection

Relay 2 N.O. – Clutch Signal

Relay 2 COM – Clutch Relay

Relay 2 N.C. – Clutch Relay

Relay 1 COM – Immobilizer Data (connector side)

Relay 3 COM – No Connection

Relay 3 N.O. – No Connection

(-) Ground

(+) 12 Volt (Battery)

Relay 1 N.C. – Immobilizer Data (vehicle side)

Relay 1 N.O. – No Connection

Description

(MUX) Parking Lights Output

Immobilizer Data Output

(-) RAP Off

HS CAN Low

HS CAN High

No Connection

HS CAN2 High

HS CAN2 Low

No Connection

Directed Digital Solutions CHRYSLER5