Zanussi ZDTS300 User Manual - Page 24

Browse online or download pdf User Manual for Dishwasher Zanussi ZDTS300. Zanussi ZDTS300 28 pages.

Print Page

WARNING!

The dishwasher must be secured against tilting.

Therefore make sure that the counter it is fixed

under, is suitably secured to a fixed structure

(adjacent kitchen units cabinets, wall).

This dishwasher is designed to be fitted under

a kitchen counter or work surface.

No further openings for the venting of the

dishwasher are required, but only to let the wa-

ter fill and drain hose and power supply cable

pass through.

The dishwasher incorporates adjustable feet to

allow the adjustment of the height.

During all operations that involve accessibility

to internal components the dishwasher has to

be unplugged.

Be sure that once the appliance has been in-

stalled, it is easily accessible for the service

engineer in the event that a repair is required.

Levelling

Good levelling is essential for correct closure

and sealing of the door.

When the appliance is correctly levelled, the

door will not catch on either side of the cabinet.

If the door does not close correctly, loosen or

tighten the adjustable feet until the machine is

perfectly level. (See enclosed template).

Water connection

WARNING!

The dishwasher must not be connected to open

water appliances or instantaneous water heat-

ers. This dishwasher may be fed with either hot

(max. 60°) or cold water. Nevertheless we ad-

vise you a cold water supply.

WARNING!

Only use, for connection to the water mains,

new hose-set; old hose-set must not be reused.

CAUTION!

If the machine is connected to new pipes or

pipes which have not been used for a long time,

you should run the water for a few minutes be-

fore connecting the inlet hose.

Water inlet hose with safety

valve

Connect the inlet hose to a water tap with an

external thread of 3/4".

After connecting the double-walled water inlet

hose, the safety valve is next to the tap.

If the water inlet hose leaks, the safety valve

cuts off the water supply.

WARNING!

The electrical cable for the safety valve is in the

double-walled water inlet hose and is live.

Therefore do not immerse the water inlet hose

or the safety valve in water.

Take care when installing the water inlet hose

. Place the water inlet hose in such a way that

it is always lower than the bottom edge of the

safety valve.

If the water inlet hose or the safety valve is

damaged, remove the mains plug immediately.