Zanussi ZSLN2321 User Manual - Page 10

Browse online or download pdf User Manual for Dishwasher Zanussi ZSLN2321. Zanussi ZSLN2321 25 pages.

Print Page

All the consumption values mentioned

in this section are determined in

accordance with the currently

applicable standard in laboratory

conditions with water hardness

2.5mmol/L according to the

2019/2022 regulation (water softener:

level 3).

The pressure and the temperature of

water as well as the variations of the

mains supply can change the values.

THE RINSE AID LEVEL

The rinse aid helps to dry the dishes without

streaks and stains. It is automatically released

during the hot rinse phase. It is possible to set the

released quantity of rinse aid.

When rinse aid chamber is empty, the rinse aid

indicator is on notifying to refill rinse aid. If the

drying results are satisfactory while using multi-

tablets only, it is possible to deactivate the

dispenser and the indicator. However, for best

drying performance, always use rinse aid and keep

the rinse aid indicator active.

To deactivate the rinse aid dispenser and indicator,

set the level of rinse aid to 0.

END SOUND

You can activate an acoustic signal that sounds

when the programme is completed.

Acoustic signals sound also when a

malfunction of the appliance occurs. It

is not possible to deactivate these

signals.

AIRDRY

AirDry improves the drying results. The appliance

door opens automatically during the drying phase

and remains ajar.

AirDry is automatically activated with all

programmes other than Pre-rinse.

CAUTION! Do not try to close the

appliance door within 2 minutes after

automatic opening. This can cause

damage to the appliance.

CAUTION! If children have access to

the appliance, we advise to deactivate

AirDry. The automatic opening of the

door may pose a danger.

KEY TONES

The buttons on the control panel make a click

sound when you press them. You can deactivate

this sound.

SETTING MODE

How to enter setting mode

You can enter setting mode before starting a

programme. You cannot enter setting mode while

the programme is running.

To enter setting mode, press and hold

simultaneously 30 min and ECO for about 3

seconds.

•

The light related to

flash.

•

The indicators

•

The lights related to the programme buttons

are on.

How to navigate in setting mode

You can navigate in setting mode using programme

buttons.

A. Previous button

B. OK button

C. Next button

Use Previous and Next to switch between the

basic settings and to change their value.

Use OK to enter the selected setting and to

confirm changing its value.

and the indicator

and

are on.