Zanussi ZT 605 Instruction Booklet - Page 13

Browse online or download pdf Instruction Booklet for Dishwasher Zanussi ZT 605. Zanussi ZT 605 15 pages. Dishwashers
Also for Zanussi ZT 605: Instruction Booklet (16 pages), Instruction Booklet (20 pages)

Print Page
Zanussi ZT 605 Instruction Booklet
SERVICING
Certain problems are due to lack of simple mainte¬
nance or oversights and can be solved easily without
having to call out an engineer.
The machine will not start
The door has not been properly closed.
The plug is not properly inserted in the power sock¬
et.
There is no current at the socket. Check the fuse.
The machine will not fill with water
The water tap is shut.
The water supply has been cut off.
The inlet hose is kinked.
The water inlet hose filter is clogged.
he machine will not drain
The drain hose is kinked.
The sink drain is blocked.
The drain hose extension is not correct.
There is no air vent in the end of the drain hose.
he dishes are not clean (poor wash)
The baskets are too full.
The dishes have not been arranged properly.
The spray arms do not rotate.
The spray arm holes are clogged.
The water inlet funnel in the centre of the upper bas¬
ket is covered by dishes.
The end of the drain hose is submerged in waste
water (in the sink).
The filters are clogged.
The filters are not in position.
Not enough detergent has been used or it is unsuit¬
able.
The detergent is old or has gone hard.
The washing programme selected is too gentle.
The machine is noisy
■ The dishes are rattling against each other.
■ The spray arms are knocking against the dishes.
The dishes are not quite dry
■ The dishes have been ieft too long inside the ma¬
chine.
The door is difficult to dose
■ The dishwasher is not level or is not properly built-
in.
if, after the above checks,
the fault persists, call
your local Zanussi Serv¬
ice Centre. Please make
sure you give the model
and serial number of the
appliance. This informa¬
tion can be found on the
rating plate located on
the right-hand side of the
dishwasher door (see picture).
Original spare parts can be purchased from Zanussi
Service Centres.
In guarantee customers should ensure that the
above checks have been made as the engineer will
make a charge if the fault is not a mechanical or
electrical breakdown.
Please note that proof of purchase is required for any
guarantee service calls.
Visible lime deposits or white film on the dishes
The rinse aid has run out or too little is being used.