Directed Directechs DB3 Installation Manual - Page 5

Browse online or download pdf Installation Manual for Automobile Electronics Directed Directechs DB3. Directed Directechs DB3 19 pages. Smart key for 2013 toyota highlander
Also for Directed Directechs DB3: Installation Manual (20 pages), Installation Manual (19 pages), Manual (6 pages), Installation Manual (18 pages), Installation Manual (18 pages), Installation Manual (20 pages), Installation Manual (19 pages), Installation Manual (20 pages), Installation Manual (10 pages), Installation Manual (19 pages), Installation Manual (19 pages), Installation Manual (20 pages), Installation Manual (20 pages), Installation Manual (20 pages), Installation Manual (10 pages), Installation Manual (20 pages), Installation Manual (20 pages), Installation Manual (19 pages), Installation Manual (20 pages), Installation Manual (20 pages), Installation Manual (18 pages), Installation Manual (20 pages), Installation Manual (19 pages), Installation Manual (19 pages), Installation Manual (18 pages), Installation Manual (19 pages), Installation Manual (20 pages), Installation Manual (18 pages), Installation Manual (19 pages), Installation Manual (20 pages), Installation Manual (20 pages), Installation Manual (20 pages), Installation Manual (18 pages), Installation Manual (20 pages), Installation Manual (19 pages), Installation Manual (20 pages), Installation Manual (18 pages), Installation Manual (19 pages), Installation Manual (20 pages), Installation Manual (17 pages), Installation Manual (20 pages), Installation Manual (18 pages)

Print Page
Directed Directechs DB3 Installation Manual

Pre-installation and application warnings

Firmware notes: This section highlights important information for this specific firmware and will assist in pricing
accordingly, as well as bringing awareness to any operational or vehicle limitations.
T-Harness
compatible
Š
Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic connector.
Š
Refer to the "Vehicle connections" following the installation diagram.
General notes: This section highlights important information for this specific firmware.
Tach wire is an optional connection required on some remote starters, which do not support a tach signal in D2D. Also please note that by
[1]
default, the tach is set to 1000 rpm on hybrid vehicles.
The installation of an aftermarket hood pin is ONLY required on vehicles that are NOT equipped with a factory hood pin. or if NOT
[2]
supported in data.
5
403.MIT5 1.06 2018 Mitsubishi RVR (Smart Key)
©2021 VOXX•DEI LLC. All rights reserved.
Keys
Keys required
1
required for
for operation
programming
0