Zanussi ZEI6840FBV User Manual - Page 10
Browse online or download pdf User Manual for Hob Zanussi ZEI6840FBV. Zanussi ZEI6840FBV 20 pages.
Print Page
Troubleshooting
Problem
You cannot activate the appliance
or operate it.
The appliance deactivates.
The residual heat indicator does
not come on.
The sensor fields become hot.
comes on.
comes on
comes on
and a number come on
comes on
If you tried the above solutions and cannot re-
pair the problem, speak to your dealer or the
10
Possible cause
You touched 2 or more sensor
fields at the same time.
There is water or fat stains on the
control panel.
You put something on the sensor
field
.
The cooking zone is not hot be-
cause it operated only for a short
time.
The cookware is too large or you
put it too near to the controls.
The Automatic Switch Off oper-
ates.
The Child Safety Device or the
Lock function operates.
No cookware is on the cooking
zone.
The cookware is incorrect.
The diameter of the bottom of the
cookware is too small for the
cooking zone.
There is an error in the appliance.
There is an error in the appliance,
because a cookware boils dry.
The protection against become
too hot for the cooking zone op-
erates. The Automatic Switch Off
operates.
customer service. Give the data from the rat-
ing plate, three digit letter code for the glass
Remedy
Activate the appliance again and
set the heat setting in less than
10 seconds.
Touch only one sensor field.
Clean the control panel.
Remove the object from the sen-
sor field.
If the cooking zone operated suf-
ficiently long to be hot, speak to
the service centre.
Put large cookware on the rear
cooking zones if necessary.
Deactivate the appliance and ac-
tivate it again.
Refer to the chapter "Daily Use".
Put cookware on the cooking
zone.
Use the correct cookware.
Move cookware to a smaller
cooking zone.
Disconnect the appliance from
the electrical supply for some
time. Disconnect the fuse from
the electrical system of the
house. Connect it again. If
comes on again, speak to the
service centre.
Deactivate the appliance. Re-
move the hot cookware. After, ap-
proximately 30 seconds activate
the cooking zone again.
should go out of the display, re-
sidual heat indicator can stay. Let
the cookware become sufficiently
cool and check it with the section
Cookware for the induction cook-
ing zone.
www.zanussi.com