Zanussi ZEV6642FBV User Manual - Page 10

Browse online or download pdf User Manual for Hob Zanussi ZEV6642FBV. Zanussi ZEV6642FBV 16 pages.

Print Page
Problem
An acoustic signal sounds and
the appliance deactivates.
An acoustic signal sounds when
the appliance is deactivated.
The appliance deactivates.
The residual heat indicator does
not come on.
The Automatic Heat Up function
does not operate.
You cannot activate the outer
ring.
The sensor fields become hot.
comes on.
comes on.
and a number come on.
If you tried the above solutions and cannot re-
pair the problem, speak to your dealer or the
customer service. Give the data from the rating
plate, three digit letter code for the glass ce-
ramic (it is in the corner of the glass surface)
and an error message that comes on.

Installation instructions

Warning! Refer to "Safety information"
chapter.
10
Possible cause
There is water or fat stains on the
control panel.
You put something on one or
more sensor fields.
You put something on the sensor
field
.
The cooking zone is not hot be-
cause it operated only for a short
time.
The cooking zone is hot.
The highest heat setting is set.
You decreased the heat setting
from
.
The cookware is too large or you
put it too near to the controls.
The Automatic Switch Off oper-
ates.
The Child Safety Device or the
Lock function operates.
There is an error in the appliance.
Make sure, you operated the appliance correct-
ly. If not the servicing by a customer service
technician or dealer will not be free of charge,
also during the warranty period. The instruc-
tions about the customer service and condi-
tions of guarantee are in the guarantee booklet.
Before the installation of the appliance, record
the information below from the rating plate. The
Clean the control panel.
Remove the object from the sensor
fields.
Remove the object from the sensor
field.
If the cooking zone operated suffi-
ciently long to be hot, speak to the
service centre.
Let the cooking zone become suffi-
ciently cool.
The highest heat setting has the
same power as the Automatic Heat
Up function.
Start from
heat setting.
Activate the inner ring first.
Put large cookware on the rear
cooking zones if necessary.
Deactivate the appliance and acti-
vate it again.
Refer to the chapter "Daily use".
Disconnect the appliance from the
electrical supply for some time.
Disconnect the fuse from the elec-
trical system of the house. Connect
it again. If
speak to the service centre.
Before the installation
Remedy
and only increase the
comes on again,
www.zanussi.com