Zanussi ZGF 646 CT User Manual - Page 16

Browse online or download pdf User Manual for Hob Zanussi ZGF 646 CT. Zanussi ZGF 646 CT 44 pages.

Print Page

Electrical connection

The appliance is designed to be
connected to 230 V monophase
electricity supply.
The connection must be carried out
in compliance with the laws and
regulations in force.
Before the appliance is connected:
1) check that the main fuse and the
domestic installation can support the
load (see the rating label);
2) check that the power supply is
properly earthed in compliance with the
current rules;
3) check the socket or the double
pole switch used for the electrical
connection can be easily reached with
the appliance built in the forniture unit.
The appliance is supplied with a
connection cable. This has to be
provided with a proper plug, able to
support the load marked on the
identification plate. The plug has to be
fitted in a proper socket.
If connecting the appliance directly
to the electric system, it is necessary
that you install a double pole switch
between the appliance and the
electricity supply, with a minimum gap
of 3 mm. between the switch contacts
and of a type suitable for the required
load in compliance with the current
rules.
The connection cable has to be
placed in order that, in each part, it
cannot reach a temperature 50°C
higher than room temperature.
The brown coloured phase cable
(fitted in the terminal block contact
marked with "L") must always be
connected to the network phase.
16
Remplacement of the voltage
cable
The connection of the voltage cable
to the appliance's terminal block is of
type
"Y".
This
replacement requires the specific
equipment of a technician. In this case,
only cable type H05V2V2-F T90 must
be used. The cable section must be
suitable to the voltage and the working
temperature. The yellow/green earth
wire must be approximately 2 cm.
longer than the phase wires (Fig. 3-a).
To open the terminal block and
reach the terminals, proceed as follows:
• insert the point of a screwdriver
into the visible protrunding part of the
terminal block;
• exert a light pressure and lift (Fig.
3-b).
means
that
its
Neutral
Earth
(yellow/green))
Fig. 3-a
Fig. 3-b