Zanussi ZGF 681 Instruction Booklet - Page 9

Browse online or download pdf Instruction Booklet for Hob Zanussi ZGF 681. Zanussi ZGF 681 12 pages. Zanussi cooktop user manual
Also for Zanussi ZGF 681: Instruction Booklet (12 pages)

Print Page

Installation

Important

This cooker must be installed by qualified personnel.

The manufacturer will not accept liability, should the above

instructions or any of the other safety instructions

incorporated in this book be ignored.

Regulations

This appliance shall be installed in accordance with the

manufacturers installation instructions, local gas fitting

regulations, municipal building codes, AS5601 (AG601)

and any other relevant statutory regulations.

Data label

The data label is located centrally on the back frame of

the appliance. This appliance is suitable for Natural or

Universal LPG. Ensure that the gas supply matches the

data label. A duplicate of the data label is supplied in the

packaging of the user manual and must be attached to

readily accessible adjacent surfaces of the appliance.

Connection to the gas supply

Gas connection must be carried out in conformity with

the regulations in force. The appliance leaves the factory

tested and regulated for the type of gas indicated on the

plate which is situated in the lower position near the gas

connection tube. Ascertain that the type of gas with

which the appliance will be supplied is the same as that

indicated on the plate.

If different carry out all the operations according to the

indications cited in the paragraph adaption to different

types of gas.

For a maximum output and minimum consumption

ascertain that the pressure of the gas used has the values

indicated in the table of burner characteristics.

The joint is mounted on the intake area of the pipe, fitted

with a filleted nut G 1/2, between the sealing components.

Screw the parts without forcing, turn the joint in the

direction required and then tighten everything.

Connection

Carry out the connection to the gas plant only by means

of a rigid metallic pipe conforming to the regulations

in force.

The joint for the entry of gas into the appliance is threaded

R 1/2 tapered.

Carry out the connection avoiding any type of stress on

the appliance.

Natural gas appliances must be fitted with a pressure

regulator and be installed at the inlet connection. The

gas pressure must then be set as a part of the

commissioning procedures.

For U-LPG the pressure adjustment is made via the

regulator fitted at the domestic cylinder.

All manuals and user guides at all-guides.com

Important

Upon completion of installation, always check:

that all the joints are completely sealed by using a

soapy solution, never a flame;

that the gas pressure has been regulated to 1.00kPa

for Natural Gas and 2.75kPa for Universal-LPG. The

pressure test point is located on the regulator for

Natural Gas models or at the top left hand rear of the

cooker for U-LPG models. The pressure should be

measured and adjusted with the Wok burner on high

flame;

that the automatic ignition system is operating

satisfactory on all burners, both individually and in

combination;

that the burners operate correctly, are stable, without

yellow tipping or excessive noise on high and low

flame.

Then demonstrate to the customer the appliance

operation and leave these instructions.

FO 0264

A) End of shaft with nut

B) Washer

C) Elbow

FO 0814