Zanussi ZGF 692 C Instruction Booklet - Page 11

Browse online or download pdf Instruction Booklet for Hob Zanussi ZGF 692 C. Zanussi ZGF 692 C 16 pages. Zanussi instruction booklet gas hob zgf 682, zgf 692
Also for Zanussi ZGF 692 C: Instruction Booklet (32 pages)

Print Page

1. Instructions for the Installer

Building In

Building over a cupboard or

drawer

If the hob is to be installed above a cupboard or drawer it

will be necessary to fit a heat resistant board below the

base of the hob on the underside of the work surface.

FO 0763

Building over a kitchen unit with

door

Proper arrangements must be taken in designing the

furniture unit, in order to avoid any contact with the bottom

of the hob which can be heated when it is operated. The

recommended solution is shown in diagram 3.

The panel fitted under the hob ("a") should be easily

removable to allow easy access if technical assistance

is needed. The space behind the kitchen unit ("b") can

be used for connections.

Fitting the Hob into the worktop

Carry out the building in of the hob as follows:

•

place the seals supplied with the hob on the side

edges of the cut out and at 8 mm from the front and

rear edges, as shown in the diagram, taking care

that the seals meet without overlapping;

•

place the hob in the cut out, taking care that it is

centred;

•

fix the hob with the relevant fixing clamps and screws,

as shown in the diagram. When the screws have been

tightened, the excess seal can be removed.

The edge of the hob forms a double seal which prevents

the ingress of liquids.

It is also recommended to carry out the electrical

connection to the hob as shown in diagrams 1 and 2.

FO 2564

FO 0199

FO 2044

Dimensions are given in mm.

Seal