Zanussi ZGG 659 Instruction Booklet - Page 10

Browse online or download pdf Instruction Booklet for Hob Zanussi ZGG 659. Zanussi ZGG 659 11 pages. Zanussi cooktop user manual

Print Page

Fitting the hob to

the worktop

Before fitting the hob into the cut out, an adhesive

seal must be fitted to the underside outside edge

(see figure 6) of the hob. It is essential that no gaps

are left in this seal in order to prevent spillage near

the hob seeping into the cabinet below.

1) Remove the pan supports, the burners

caps and crowns and turn the hob upside

down, taking care the ignition candles are

not damaged in this operation.

2) Place the sealing gasket all around the

glass top edge as shown in diagram.

3) Fit the hob in the cut out and push it down

until the glass top and the working top

make contact, as shown in figure 7.

Electrical connection

Any electrical work required to install this

appliance should be carried out by a

qualified electrician or competent person,

in accordance with the current regulations.

THIS

APPLIANCE

EARTHED.

The manufacturer declines any liability should

these safety measures not be observed.

This appliance is designed to be connected to

a 230 V 50Hz AC electrical supply.

Before the appliance is connected:

1) check that the main fuse and the domestic

installation can support the load (see the rating

label);

2) check that the power supply is properly earthed

in compliance with the current rules;

3) check the socket or the double pole switch used

for the electrical connection can be easily

reached with the appliance built in the forniture

unit. Before switching on, make sure the

electricity supply voltage is the same as that

indicated on the appliance rating plate. The

rating plate is located on the bottom of the hob.

A copy is attached on the back cover of this book.

The appliance is supplied with a 3 core flexible

supply cord incorporating a plug. Connect the plug

to an adequate socket.

Permanent Connection

MUST

In the case of a permanent connection, it is

necessary that you install a double pole switch

between the appliance and the electricity supply

(mains), with a minimum gap of 3 mm. between

the switch contacts and of a type suitable for the

required load in compliance with the current electric

regulations.

The switch must not break the yellow and green

earth cable at any point.

Fig. 6

FO 2108

FO 2107

Ensure that the hob supply cord does

not come into contact with surfaces

with temperatures higher than 50 deg.

A) Sealing gasket

Fig. 7