Zanussi ZGG 742 E Instruction Booklet - Page 21
Browse online or download pdf Instruction Booklet for Hob Zanussi ZGG 742 E. Zanussi ZGG 742 E 40 pages. Electronic gas hob
Print Page
Something not working?
I f the hob is not working correctly, please carry out the following checks before contacting
your local Service ForceCentre. IMPORTANT: If you call out an engineer to a fault listed
below, or to repair a fault caused by incorrect use or installation, a charge will be made even
if the appliance is under guarantee.
PROBLEM
THE HOB
DOESN'T
WORK
A BURNER
DOESN'T
WORK
IT TAKES TOO LONG
TO FINISH THE
DISHES / THEY ARE
COOKED TOO FAST.
CAUSE
There are blown fuses in the
domestic electrical system.
Switches are turned off or
there is no power at the
power outlet.
The hob is not activated.
The main gas supply tap is
closed.
The gas bottle is empty.
The hob has overheated and
a safety device has been set
on the four burners.
The Child Safety function
has been inadvertently
activated.
The safety device has been
set on the burner due to
repeated ignition failures.
The flame level indicators
and the residual heat
indicator flash.
The pan support or the
burner cap and crown were
not correctly positioned
after cleaning.
The burner crown holes are
obstructed.
The defect persists.
The flame level adjustment
is not appropriate.
SOLUTION
Have the fuses replaced.
Reset the switches.
Touch the main On/Off
Control
.
Open the tap.
Purchase a new bottle.
Allow the top to cool (see
par. "Protection against
overheating").
Deactivate the Child
Safety function (see par.
"Child Safety Function").
Wait 60 seconds, then
follow the instructions
given in chapter: "In case
of ignition failure".
Check
the
position (see par. "In case
of ignition
failure").
Follow the instructions
given in the section
"Cleaning
maintenance".
Contact an authorized
technical
assistance
centre.
See paragraph "How to
light a burner"
correct
and
21