Zanussi ZGG96624 User Manual - Page 24

Browse online or download pdf User Manual for Hob Zanussi ZGG96624. Zanussi ZGG96624 44 pages. Hob
Also for Zanussi ZGG96624: User Manual (16 pages), User Manual (16 pages), User Manual (16 pages), User Manual (48 pages)

Print Page

Model .......................................

PNC .........................................

Serial number ...........................

Gas Connection

WARNING!

The following instructions about

installation, connection and

maintenance must be carried out by

qualified personnel in compliance

with standards and local regulations

in force.

It is necessary that the connection to the gas

mains are carried out by means of an AGB tap.

Choose fixed connections or use a flexible pipe

in AGB (stainless steel) in compliance with the

regulation in force (NBN D 51.003). If you use

flexible metallic pipes, be careful they do not

come in touch with mobile parts or they are not

squeezed. Also be careful when the hob is put

together with an oven.

Make sure that the gas supply

pressure of the appliance obeys the

recommended values. The

adjustable connection is fixed to the

comprehensive ramp by means of a

threaded nut G 1/2". All the

components shown in the figure

have already been assembled in the

factory. The appliance, before

leaving the factory, has been tested

in order to give you the best results.

B C

A) End of shaft with nut

B) Washer

C) Elbow (if needed)

Liquid gas

Use the rubber pipe holder for liquid gas.

Always engage the gasket. Then continue with

the gas connection.

The flexible pipe is prepared for apply when:

• it can not get hot more than room

temperature, higher than 30°C;

• it is no longer than 1500 mm;

• it shows no throttles;

• it is not subject to traction or torsion;

• it does not get in touch with cutting edges or

corners;

• it can be easily examined in order to make

sure its condition.

The control of preservation of the flexible pipe

consists in checking that:

• it does not show cracks, cuts, marks of

burnings on the two ends and on its full

length;

• the material is not hardened, but shows its

correct elasticity;

• the fastening clamps are not rusted;

• expired term is not due.

If one or more defects are visible, do not repair

the pipe, but replace it.

WARNING!

When installation is complete, make

sure that the seal of each pipe fitting

is correct. Use a soapy solution, not

a flame!

Injectors replacement (only for

Belgium)

1. Remove the pan supports.

2. Remove the caps and crowns of the burner.

3. With a socket spanner 7 remove the

injectors and replace them with the ones

which are necessary for the type of gas you

use (see table in "Technical Information"

chapter).

4. Assemble the parts, follow the same

procedure backwards.

5. Replace the rating plate (it is near the gas

supply pipe) with the one for the new type

of gas supply. You can find this plate in the

package supplied with the appliance.

If the supply gas pressure is changeable or

different from the necessary pressure, you must

fit an applicable pressure adjuster on the gas

supply pipe.

Adjustment of minimum level (only for

Belgium)

To adjust the minimum level of the burners:

1. Light the burner.

2. Turn the knob on the minimum position.

3. Remove the knob.

4. With a thin screwdriver, adjust the bypass

screw position (A).