Zanussi ZGL 646 Instruction Booklet - Page 5

Browse online or download pdf Instruction Booklet for Hob Zanussi ZGL 646. Zanussi ZGL 646 13 pages.
Also for Zanussi ZGL 646: Instruction Booklet (11 pages)

Print Page

Instruction for the User

Once the hob has been installed, it is

important to remove any protective materials,

which were put on in the factory.

Hob burners control knobs

The hob burners control knobs are situated on the hob

right hand side. The symbols on the knobs mean that:

there is no gas supply

there is maximum gas supply

there is minimum gas supply

Lighting the burners

For easier lighting, proceed before putting a

pan on the pan support.

To light a burner:

1. push in the relevant knob and turn it anticlockwise to

"maximum position".

2. Hold a flame near the burner.

3. Then, check the flame is regular and adjust it as

required.

If you cannot light the flame even after several attempts,

check the "cap" (Fig. 1, lett. A) and the "crown" (Fig.

1, lett. B) are in the correct position.

To put the flame out, turn the knob to the symbol .

•

Always turn the flame down or put it out before

taking the pans off the burner.

Using the hob correctly

To ensure maximum burner efficiency, it is strongly

recommended that you use only pots and pans with a

bottom fitting the size of the burner used, so that flame will

not spread beyond the bottom of the vessel (see the table

beside) (Fig. 2).

It is also advisable, as soon as a liquid starts boiling, to

turn down the flame so that it will barely keep the liquid

simmering.

Use only pans or pots with flat bottom.

Carefully supervise cookings with fats or

oil, since these types of foodstuff can result

in a fire, if over-heated.

Fig. 1

FO 0204

A - Burner cap

B - Burner crown

Burner

minimum

diameter

Large (rapid)

Medium (semirapid)

Small (auxiliary)

Fig. 2

maximum

diameter

180 mm

260 mm

120 mm

220 mm

80 mm

160 mm