Zanussi ZBB27450SV User Manual - Page 9
Browse online or download pdf User Manual for Freezer Zanussi ZBB27450SV. Zanussi ZBB27450SV 17 pages.
Also for Zanussi ZBB27450SV: User Manual (17 pages)
Print Page
Problem
Water flows inside the refriger-
ator.
Water flows on the floor.
The temperature in the appli-
ance is too low/too high.
If the advice does not lead to the
desired result, contact the nearest
Authorised Service Centre.
REPLACING THE LAMP
The appliance is equipped with a long-
life LED interior light.
Possible cause
Food products placed in the
appliance were too warm.
The door is not closed cor-
rectly.
The water drainage plug is
not correctly positioned.
Food products are not wrap-
ped properly.
Temperature is set incorrect-
ly.
Food products prevent the
water to flow into the water
collector.
The water outlet is clogged.
The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
The temperature regulator is
not set correctly.
The door is not closed cor-
rectly.
The food products' tempera-
ture is too high.
Many food products are stor-
ed at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened
often.
There is no cold air circula-
tion in the appliance.
Solution
Allow food products to cool to
room temperature before storing.
Refer to "Closing the door".
Position the water drainage plug
in the correct way.
Wrap the food products better.
Refer to "Operation" .
Make sure that food products do
not touch the rear plate.
Clean the water outlet.
Attach the melting water outlet to
the evaporative tray.
Set a higher/lower temperature.
Refer to "Closing the door".
Let the food products tempera-
ture decrease to room tempera-
ture before storage.
Store less food products at the
same time.
Defrost the appliance.
Open the door only if necessary.
Make sure that there is cold air
circulation in the appliance.
It is strongly recommended to use
original spare parts only.
Use LED bulbs (E14 base) only. The
maximum power is shown on the lamp
unit.
9