Zanussi ZEC 30 Instruction Booklet - Page 7
Browse online or download pdf Instruction Booklet for Freezer Zanussi ZEC 30. Zanussi ZEC 30 15 pages. Zanussi instruction booklet freezer zec 30
Print Page
Fitting a decorative door panel
Important: The components needed to fit the decorative
panel have been pre-fitted on the appliance.
The brackets are secured to the panel by means of the 7
Ø 3.5x13 screws supplied.
Before starting to fit the panel, remove the large top
bracket by unscrewing the screws and adjusting pins
pre-fitted on the appliance door. The small bottom
bracket need not be removed.
Place the appliance in the position where it is to be
built in (Fig. 6).
The appliance is fitted with adjustable feet; screw
the front and rear feet in or out to adjust the height
of the appliance to that of the recess.
Keeping the appliance central in the recess, slide it
in until its back touches the wall.
With a tape measure (or similar instrument),
measure distance (A) between the top edge of the
door and the top edge of the decorative panel,
placing it next to the recess.
A
=
=
D467
Lay the panel face down (Fig. 7). Position the top
bracket on the panel, making sure that there is an
equal distance between it and the sides and that its
distance from the top edge is equal to distance (A)
less 1 cm.
Secure the bracket with the screws supplied.
Take care not to damage the front face of the panel
whilst working.
D468
Fig. 6
Fig. 7
A
-1cm
Insert the adjusting pins (B-Fig. 8) into their
locations in the door and screw them in.
B
D532
Hook the decorative panel onto the top part of the
door, inserting the pins (B) (on the door) into the
elongated holes (1) (in the top bracket fitted to the
panel) (Fig. 9).
Insert the securing screws (C) through elongated
holes (2) and fix the panel without tightening the
screws (Fig. 9).
1
B
C
2
D533
Fig. 8
Fig. 9
7