Zanussi ZF711W Instruction Booklet - Page 5
Browse online or download pdf Instruction Booklet for Freezer Zanussi ZF711W. Zanussi ZF711W 20 pages. Zanussi instruction freezer zf711w
Before use
·
Remove all securing tapes.
·
Wash the inside of the appliance with lukewarm
water with a little bicarbonate of soda added (5ml to
0,5 litre of water). Do not use soap or detergent as
the smell may linger. Dry the appliance thoroughly.
Do not use detergents, abrasive powders,
highly perfumed cleaning products, wax,
polishes or products containing alcohol.
To start the freezer and thermostat
control
Plug in the appliance.
Turn the thermostat control to the desired position.
1 : The lowest position of the thermostat control
results in the highest temperature inside the cabinet.
6 : The highest position of the thermostat control
results in the lowest temperature inside the cabinet.
0 : Off.
Allow the cabinet to run for a period of 24 hours
whenever the temperature setting is changed. This
will allow the temperature to stabilise inside the
cabinet.
Temperature inside the freezer
To ensure that foodstuff will keep for a long time, be
sure that the temperature inside the freezer is -18°C
or below. Please note, however, that the energy
consumption increases as the temperature decreases.
Switching off
Set the thermostat control to the "0" position.
Unplug the power supply plug from the wall socket.
Alarms and other features
Temperature alarm
The red warning light illuminates when the
temperature inside the cabinet rises above -12°C.
The light goes out again when the temperature falls
below -13°C.
Freezing
You need not press the fast-freezing button when
freezing smaller quantities of food during any
24-hour period.
In all other cases, press the fast-freezing button
approx. 24 hours prior to placing the food in the
freezer.
Press the fast-freezing button to switch off
fast-freezing again about 24 hours after placing the
food in the freezer.
The yellow fast-freezing lamp remains lit as long as
the fast-freezing button is engaged.
·
Before inserting the power plug into the outlet and
switching on the cabinet for the first time, leave it
standing upright for about 30 minutes, or for 2 hours
if it was transported horizontally. Otherwise the com-
pressor may sustain damage. This time will allow the
oil sufficient time to return to the compressor.
5
Zanussi 818 15 02--03/3