Zanussi ZFU20200WA User Manual - Page 11

Browse online or download pdf User Manual for Freezer Zanussi ZFU20200WA. Zanussi ZFU20200WA 16 pages.
Also for Zanussi ZFU20200WA: User Manual (36 pages)

Print Page

3. Connect the wire coloured brown to the

terminal either marked with the "L" or col-

oured red.

4. Check that no cut, or stray strands of wire

is present and the cord clamp E is secure

over the outer sheath.

5. Make sure the electricity supply voltage is

the same as that indicated on the appli-

ance rating plate.

6. Switch on the appliance.

The appliance is supplied with a 13 amp plug

fitted B. In the event of having to change the

fuse in the plug supplied, a 13 amp ASTA ap-

proved (BS 1362) fuse must be used.

Warning! A cut off plug inserted into a 13

amp socket is a serious safety (shock)

hazard. Ensure that it is disposed of safely.

Rear spacers

You can find the two spacers in the bag with

documentation.

Do these steps to install the spacers:

1. Release the screw.

2. Engage the spacer below the screw.

3. Turn the spacer to the right position.

4. Tighten again the screws.

www.zanussi.com

Levelling

When placing the appliance ensure that it

stands level. This can be achieved by two ad-

justable feet at the bottom in front.

Door reversibility

Important! To carry out the following

operations, we suggest that this be made with

another person that will keep a firm hold on the

doors of the appliance during the operations.

To change the opening direction of the door,

do these steps:

• Remove the plug from the power socket.

• Tilt back the appliance carefully so that the

compressor cannot touch the floor.

• Remove the plinth (1).

• Remove the cap (2) and position it on the

opposite side.

• Unscrew and remove the lower hinges. (3)

• . Remove the door.

• Unscrew the upper pin (1) and place it on

the opposite side. (2)

• Refit the door.