Zanussi ZFX51400WA User Manual - Page 21

Browse online or download pdf User Manual for Freezer Zanussi ZFX51400WA. Zanussi ZFX51400WA 48 pages.
Also for Zanussi ZFX51400WA: User Manual (12 pages)

Print Page

1. Remove the plug

from the power socket.

2. Remove the top

hinge cover.

3. Unscrew the 2 re-

taining screws, and re-

move the hinge from

the appliance.

4. Take the door off.

Do a final check to make sure that:

• All screws are tightened.

• The door opens and closes correctly.

If the ambient temperature is cold (i.e. in Win-

ter), the gasket may not fit perfectly to the cabi-

net. In that case, wait for the natural fitting of the

gasket.

In case you do not want to carry out the above

mentioned operations, contact the nearest After

Sales Service Force. The After Sales Service

specialist will carry out the reversibility of the

doors at your cost.

Electrical connection

Before plugging in, ensure that the voltage and

frequency shown on the rating plate correspond

to your domestic power supply.

www.zanussi.com

5. Remove the screw

fixing the lower door

hinge and the other

screw fixing the lower

door hinge and the

foot. Then remove the

door hinge and the

foot as shown in the

Figure.

6. Loosen the screw

fixing the foot opposite

the lower door hinge in

order to remove the

foot.

7. Fix the door hinge

and the corresponding

foot on the opposite

side and then the oth-

er loosened foot at the

former place of the

door hinge as shown

in the Figure.

8. Please make sure

to place the lower

foot below the door

hinge. The lower

foot is recognizable

by its 4 ribs on the

outer surface.

9. Fix the door onto

the lower hinge pin.

10. To fit top door

hinge, remove the

plastic blanking plugs

carefully, and refit

them in the holes left

by the hinge retaining

screws.

The appliance must be earthed. The power sup-

ply cable plug is provided with a contact for this

purpose. If the domestic power supply socket is

not earthed, connect the appliance to a sepa-

rate earth in compliance with current regula-

tions, consulting a qualified electrician.

The manufacturer declines all responsibility if

the above safety precautions are not observed.

This appliance complies with the E.E.C. Direc-

tives.

11. Refit the top hinge

using the 2 retaining

screws, taking care

that the edge of the

door is parallel with

side of the cabinet.

12. Replace the hinge

cover.

13. Relocate the han-

dle and the plastic

plugs to the opposite

side.

14. Level the appli-

ance, wait for at least

four hours and then

connect it to the pow-

er socket.