Zanussi ZV320P-1 Instruction Booklet - Page 8

Browse online or download pdf Instruction Booklet for Freezer Zanussi ZV320P-1. Zanussi ZV320P-1 12 pages.

Print Page

When the appliance is not in use

Disconnect the appliance from electricity supply.

Empty all foods and clean the appliance, leaving the

doors ajar to prevent unpleasant smells.

If the cabinet will be kept on, ask somebody to

check it once in a while to prevent the food inside

from spoiling in case of a power failure.

Something Not Working

Before contacting your local Service Force Centre check the following point:

Problem

It is too warm inside the freezer.

It is too cold inside the freezer.

Too much frost and ice are produced.

The compressor operates continuously.

The cabinet does not operate at all.

Cooling or interior light does not

operate. No indicator lamps light.

Sound level in cabinet is too high.

Possible cause / Remedy

Set a lower temperature.

Make sure that the door is completely closed and that the

insulating strip is complete and clean.

If warm food products have been put inside the freezer, wait for

a couple of hours and then check the temperature again.

Distribute the food products to allow cold air to circulate

around them.

Set a warmer temperature.

Action Freeze could have been switched on.

Make sure that the door is completely closed and that the

insulating strip is complete and clean.

Set a warmer temperature.

Make sure that the door is completely closed and that the

insulating strip is complete and clean.

The temperature where the cabinet is placed is above normal

room temperature.

The cabinet is not switched on.

Power does not reach the cabinet. (Try connecting another

electrical device to the power outlet.)

The fuse has blown.

The power plug is not properly connected.

The refrigerating system will always produce some sounds. A

pulsing sound is heard when coolant is pumped inside the

cooling pipes. A ticking sound from the thermostat can be

heard when the compressor switches on and off. The sound

level varies depending on the operation of the cabinet.

If you feel the sound level is incorrect:

Make sure the pipes at the back of the cabinet not touch each

other. Carefully bend them if they do.

If the cushion spacers (between the cabinet wall and pipes)

come loose, put them back in place again.

Carefully follow the instructions in the chapter "Installing the

cabinet".

Zanussi 818 14 97-02/8