Zanussi ZVC 67 Instruction Booklet - Page 5

Browse online or download pdf Instruction Booklet for Freezer Zanussi ZVC 67. Zanussi ZVC 67 15 pages.

INSTALLATION

Warning
IF YOU ARE DISCARDING AN OLD
APPLIANCE THAT HAS A LOCK OR CATCH
ON THE DOOR, PLEASE ENSURE THAT IT IS
MADE UNUSABLE TO PREVENT YOUNG
CHILDREN BEING TRAPPED INSIDE.
Depending upon the position which you choose for
your appliance, you may wish to reverse the way in
which the door opens. To do this, refer to
instructions on "Door reversal directions"
paragraph.

Positioning

This appliance is designed to operate in ambient
temperatures between 10 C (50 F) and 32 C (90 F).
It should be located in a dry atmosphere, out of
direct sunlight and away from extreme
temperature e.g. not next to a cooker or other
sources of direct heat, or in a very cold room e.g. an
outhouse, where the temperatures may fall below
10 C (50 F). If these temperatures are exceeded i.e.
colder or warmer, then the appliance may not
operate correctly.
You should also ensure that air can circulate freely
around the back and the top of the cabinet. There
must also be at least 100 mm (4") distance between
the top of the cabinet and any overhanging kitchen
furniture (Fig. 1-A). Ideally, the appliance should
not be positioned beneath overhanging furniture
(Fig. 1-B).
A
B
NP008
Fig. 1
There should also be a gap of 25 mm either side of
the appliance. Do not obstruct the space
underneath. The back of the cabinet may be placed
close to the wall but must not touch it. DO NOT
install in places with restricted ventilation.
Adjust the level of the appliance by screwing out
the adjustable foot, or feet, at the bottom of the
cabinet using your fingers or a spanner (see Fig. 2).
D200

Rear spacers

The plastic bag containing all relevant
documentation also contains two rear wall spacers
to be fitted into special slots on the back of the
appliance. Fit the spacers into the slots, taking care
to ensure that the arrow (A) is positioned as shown
in Figure 3.
Next, turn them through 45 (arrow in vertical
position) until they lock into place.
A
45°
D039
Fig. 2
Fig. 3
5