Zanussi ZHC 950 Instruction Booklet - Page 15

Browse online or download pdf Instruction Booklet for Ventilation Hood Zanussi ZHC 950. Zanussi ZHC 950 21 pages. Zhc 950
Also for Zanussi ZHC 950: Installation And Use Manual (10 pages)

Print Page

Fitting the Hood Body

Before starting to fix the hood body,

tighten the two screws Vr located on

the top of the hood body.

Hook the hood body onto the two

4.2x44.4mm screws item 12a.

Fully tighten the screws item 12a.

Using a screw driver and spirit level,

adjust the screws item Vr until the

hood body is level.

Extraction

The cooker hood is more effective when used

in the extraction mode (ducted to the outside).

Venting kits may be purchased through

your retailer or DIY store, and must be

ducted to an outside vent of Ø125mm (5")

or Ø150mm (6").

The ducting used must be manufactured

from fire retardent material conforming to the

relevant British Standard or DIN 4102-B1.

When the cooker hood is ducted to the outside

the charcoal filter must be removed.

Recirculation

The cooker hood is supplied specified for use in

the recirculation mode, with the charcoal filter

fitted.

In the recirculation mode contaminated air is

passed through the charcoal filter to be purified

and recirculated into the kitchen through the

grille outlets on either side of the chimney.

To assemble the recirculation duct, place the

recirculation outlet connection item 15 into the

support item 7.3.

Insert the extension ducts item 14.1 into either

side of the recirculation outlet item 15 ensuring

the connections are vertically and horizontally

aligned with the outlets in the chimney.

Connect the recirculation oulet item 15 to the

outlet on top of the hood body using either a

piece of Ø125mm or Ø150mm flexible or rigid

pipe.

Rigid pipe is strongly recommended and should

be used where possible as this will ensure the

best performance while lowering noise.