Zanussi ZHP 631 Installation, Use And Maintenance Handbook - Page 12

Browse online or download pdf Installation, Use And Maintenance Handbook for Ventilation Hood Zanussi ZHP 631. Zanussi ZHP 631 40 pages.
Also for Zanussi ZHP 631: Installation & Use Manual (11 pages), Instruction Manual (40 pages)

Print Page

INSTALLATION

Drilling the Support surface and Fitting the Hood

• The hood support surface must be 135 mm above the bottom

surface of the wall units.

• Drill the support with a ø 4,5 mm drill bit, using the drilling

template provided.

• Cut a hole ø 125 mm in size on the support surface, using the

drilling template provided.

• Fix using the 4 screws 12a (4,2 x 44,4) provided.

• The hood can be installed either directly on the bottom surface

of the wall units using snap-on side supports.

• Cut a fitted opening in the bottom surface of the wall unit, as

shown.

• Insert the hood until the side supports snap into place.

• Lock in position by tightening the screws Vf from underneath

the hood.

• The space between the edge of the hood and the rear wall can

be closed by applying the element 20 provided, using the

screws supplied for this purpose.

SCREW FITTING

SNAP-ON FITTING

CLOSING ELEMENT

Downloaded from www.vandenborre.be

12a

125

264