Zanussi GAS COOKER ZCG 641 Instruction Booklet - Page 16

Browse online or download pdf Instruction Booklet for Cookers Zanussi GAS COOKER ZCG 641. Zanussi GAS COOKER ZCG 641 20 pages. Zanussi cooktop user manual

Print Page

FO 0179

Fig. 2

Fitting the Stability Bracket

(Not supplied)

If the cooker has to be installed with a flexible supply

pipe, it is necessary that a stability device is fitted.

(See "Important Safety Requirements").

The stability bracket is to be fitted by the installer and

these instructions should be read in conjunction with

the leaflet packed with the stability bracket.

Place the cooker in its intended position and level

cooker.

Mark off 295mm (11

") from the right hand side of the

cooker as shown, this is the centre line of the bracket

fixing.

Draw a line 100mm (4") from the front edge of the

levelling feet (see Fig. 2) and remove cooker from its

position. Mark off 480mm (19") back from this line on

the centre line of the bracket to locate the front edge of

the lower bracket.

Fix lower bracket (with two fixing holes) to the floor, then

measure height from floor level to engagement edge on

back of cooker, dimension 'A' of Fig. 2.

Assemble upper bracket to lower bracket so that

underside of bracket is dimension 'A' +3mm (1/8") above

floor level. Re-position cooker and check that top

bracket engages into cooker back to a depth of 75mm

(3"), as shown in Fig. 2.

Should the stability bracket currently installed not allow

the cooker to stand correctly, ask the installer to replace

it with the correct type.

Connecting to Gas

This cooker is designed to be installed with an appliance

flexible connection. Connection is made to the RC 1/2

(1/2" B.S.P.) threaded entry pipe located just below the

hotplate level on the rear right-hand side of the cooker.

Check for gas soundness after connecting the gas

supply.

The gas bayonet connector must be fitted in the shaded

area indicated in the diagram. Take into account that it

must be possible to pull the cooker forward sufficiently.

The hose must not get caught on the stability bracket.

Note:

For certain types of gas bayonet connection used, it

may not be possible for the appliance to be pushed fully

back to the wall stops.

Important:

Flexible tubing MUST comply with BS.669 Current

Edition.

600

FO 0180

450

130

Fig. 3