Directed Directechs DB3 Installation Manual - Page 9

Browse online or download pdf Installation Manual for Automobile Electronics Directed Directechs DB3. Directed Directechs DB3 18 pages. Smart key for 2013 toyota highlander
Also for Directed Directechs DB3: Installation Manual (20 pages), Installation Manual (19 pages), Manual (6 pages), Installation Manual (18 pages), Installation Manual (18 pages), Installation Manual (19 pages), Installation Manual (20 pages), Installation Manual (19 pages), Installation Manual (20 pages), Installation Manual (10 pages), Installation Manual (19 pages), Installation Manual (19 pages), Installation Manual (20 pages), Installation Manual (20 pages), Installation Manual (20 pages), Installation Manual (10 pages), Installation Manual (20 pages), Installation Manual (20 pages), Installation Manual (19 pages), Installation Manual (20 pages), Installation Manual (20 pages), Installation Manual (18 pages), Installation Manual (20 pages), Installation Manual (19 pages), Installation Manual (19 pages), Installation Manual (18 pages), Installation Manual (19 pages), Installation Manual (20 pages), Installation Manual (18 pages), Installation Manual (19 pages), Installation Manual (20 pages), Installation Manual (20 pages), Installation Manual (20 pages), Installation Manual (18 pages), Installation Manual (20 pages), Installation Manual (19 pages), Installation Manual (20 pages), Installation Manual (19 pages), Installation Manual (20 pages), Installation Manual (17 pages), Installation Manual (20 pages), Installation Manual (18 pages)

Print Page
Directed Directechs DB3 Installation Manual

Module programming

Refer to "LED diagnostics and troubleshooting" for more information and for troubleshooting purposes.
For
Convenience-Only
programming, see next section.
Ensure vehicle is in a safe location and cannot move forward during programming. For
1
vehicles equipped with a manual transmission, make sure the gearshift is in the neutral
position.
The harnesses must be connected in this exact order:
  1. Connect the 14-pin.
  2. Connect the 12-pin.
2
  3. Connect the 10-pin.
  4. Connect the 4-pin D2D cable (if being used).
When the LED turns ON solid red, proceed with the next step.
Insert and turn the key to the ON position. The LED will first flash orange, then will turn ON
3
solid green or orange for 3 seconds, and it will finally shut OFF.
4
Turn the key to OFF, and remove it from the ignition barrel.
You have successfully completed the module programming sequence.
9
403.CHRYSLER2 3.13 2003 Jeep Liberty
©2023 Directed. All rights reserved.