Zanussi Z 9060 XOS Instructions For Use And Installation Instructions - Page 7

Browse online or download pdf Instructions For Use And Installation Instructions for Cookers Zanussi Z 9060 XOS. Zanussi Z 9060 XOS 37 pages. Cookers z 9060wos; z 9060 xos

Print Page
ELECTRIC SPARK IGNITION
To light the burner you have to rotate
the knob corresponding to the specific
burner to the maximum flame position
(large flame symbol) and press the igni-
tion button marked by the symbol
(fig. 3.3).
The sparks produced by the electrodes
situated next to the burner will light the
selected burner.
If conditions of the local gas supply
makes it difficult to light the gas burner
with the knob set to the high flame
position, rotate the knob to the lower
flame position and repeat the ignition.
If the burner flame should go out
accidentally wait for at last 1 minute
before re-light the burner.
Fig. 3.2
Fig. 3.3

CHOICE OF THE BURNER

On the control panel, near every knob,
there is a diagram that indicates which
burner is controlled by that knob.
The suitable burner must be chosen
according to the diameter and the
capacity used.
As an indication, the burners and the
pots must be used in the following way:
BURNERS
Auxiliary
Semi-rapid
Rapid
Double-ring
do not use pans with concave or convex bases
Fig. 3.4
It is important that the diameter of the
pot be suitable to the potentiality of the
burner so as not to compromise the high
output of the burners and therefore
energy waste.
A small pot on a large burner does not
give you a boiling point in a shorten
amount of time since the capacity of
heat absorption of a liquid mass
depends on the volume and the surface
of the pot.
N.B. When the cooker top is not
being used, set the gas knobs
to their closed positions and
also close the cock valve on
the gas bottle or the main gas
supply line.
POT DIAMETER
12 - 16 cm
16 - 22 cm
20 - 24 cm
up to 30 cm
7