Clarke Pioneer 205 Operating And Maintenance Instructions Manual - Page 5
Browse online or download pdf Operating And Maintenance Instructions Manual for Air Compressor Clarke Pioneer 205. Clarke Pioneer 205 7 pages.
Also for Clarke Pioneer 205: Operating & Maintenance Instructions (8 pages)
Print Page
PREPARATION FOR USE
NOTE: All numbered items throughout this manual refer to the parts list item number
on Page 14.
1. Remove the plastic travel plug from the oil filler hole, on the
top of the crank case, and insert the dipstick (see Fig. 6 - p.8).
2. Check the oil level is at the correct level on the dipstick, as
shown in Fig.1. Where necessary, top up with Clarke SAE40
Compressor Oil available from your Clarke dealer.
OPERATION
(Ref. Figs. 2 and 2A)
NOTE: if you intend using your compressor for spraying, read also the Helpful
Hints on Spraying booklet - supplied with the machine.
1. Check that the mains voltage corresponds with that shown on the data sticker
on the crankcase cover of the machine.
2. Ensure that the ON/OFF knob is in the OFF (0) position, i.e. pushed DOWN,
then plug in and switch on at the mains supply.
3. To start the compressor pull UP the ON/OFF knob to the ON (I) position
- the motor should start immediately.
Note: Should the motor fail to start immediately, it is probable that the air receiver
is already full of air. Check the tank pressure gauge (see fig. 2). If you release air,
by opening air outlet tap, the motor will start automatically once the cut-in pressure
is reached.
4. Before connecting your
Fig. 2
airline to the compressor,
allow it to run for 10 - 15
seconds, with the air outlet
tap completely open to
permit a good distribution
of the lubricating oil.
5. Close the outlet tap then
connect one end of
suitable air hose to the
compressor air outlet, and
the other end to the
equipment to be used.
Set the outlet pressure by
Fig.1
6
SPECIFICATIONS
Rotational Speed................................................ 2850 rpm
Max.Pressure
................................................... 10 bar
Air Displacement ................................................ 200L/min (7 cfm approx.)
Electric Motor ................................................... 1.5 hp (1.1 kW)
Receiver
................................................... 9.5 Ltr
Compressor Oil ................................................... CLARKE SAE 40
Fuse Rating
................................................... 13amps
Duty Cycle
................................................... S1 at max. 7 bar.
(i.e. Compressor may run continuously at 7 bar max.)
Please note that the details and specifications contained herein, are correct at the time of going to
print. However, CLARKE International reserve the right to change specifications at any time without
prior notice. Always consult the machines data plate
ACCESSORIES
Your Clarke Pioneer 205 Air Compressor can be used in conjunction with a range
of optional accessories for inflating tyres, air brushing, stapling, blowing and many
other uses. For details contact your local accessory stockist.
A complete kit -
, illustrated below, is available from your Clarke
Model KIT 1000
dealer which is ideal for almost all applications.
Please quote part number 3110155
A similar kit is available, without the spray gun -
The accessories are also available separately
Should you experience any difficulties obtaining accessories, please contact the
Clarke sales department (telephone 01992 565300) for details of your nearest
dealer.
Model KIT 600, Part No. 3110150
11