Alecto DBX-90 Owner's Manual - Page 7

Browse online or download pdf Owner's Manual for Baby Monitor Alecto DBX-90. Alecto DBX-90 8 pages. 1.8ghz dect baby monitor, talk back, nightlight with lullaby

Print Page
Parent Unit
•
Press
at the Parent unit when lullaby is not being played.

Stopping the Lullaby Playing

Baby Unit
When lullaby is playing,
•
Press
to stop the Lullaby.
Parent Unit
When lullaby is playing,
•
Press
to stop the Lullaby.

Out of Range

When the baby and parent units have no link with each other (eg. Out
of range, parent unit or Baby unit is not powered on), the green Link
LED flashes. If there is no link for more than 30 seconds, the red Link
LED flashes and the green Link LED turns off. The link break alert will
also be emitted from the speaker of the Parent Unit every 30 seconds.
When the units are linked, the green Link LED will be steadily lit.
Note: Link break alert cannot be manually set on or off, but it can be
suppressed for 4 minutes by pressing any button.
There is only visual alert shown on the Baby Unit.

Low Battery

Baby Unit
When the unit is running on battery power and reaches low battery
level, the Low Battery LED will steadily turn on. Once the low battery
level is reach, the baby unit should still be able to operate for an hour.
Parent Unit
When the batteries on the Parent Unit reach a low level, the Low
Battery LED flashes. The low battery alert tone will be emitted from the
speaker every 60 seconds. Once the low battery level is reached, the
parent unit should still be able to operate for an hour. The low battery
alert message and alert tone will be turned off when fully charged
batteries are being replaced.
Note: Low battery alert can be suppressed by pressing any button.

Charging the Battery

Place the parent unit on its charge cradle to charge the battery. When
charging, the red LED on the charger will light steadily. The Low
Battery LED will be turned off.
Note: The Parent Unit must never be operated on the charging cradle
without batteries.

Restore to Default Setting

You can return the baby and parent units to factory default settings.
•
Press
to switch the unit off.
•
Press
again to switch the unit back on.
•
While the unit is switching on, press and hold
beep. The unit will restore all the original factory settings.
Note: If
is not pressed within 4 seconds, the unit returns to idle
mode.
If you want to restore the factory default settings on the baby
monitor, you will need to restore factory default setting on the
Baby Unit or on the Parent Unit individually.

Appendix: Default Settings

Baby Unit
Speaker Volume: Level 3
Lullaby: Lullaby 1
Parent Unit
Speaker Volume: Level 1
Speaker Sensitivity: Level 5
until you hear a
7