Directed Directechs DB3 Installation Manual - Page 16

Print Page

Parking light error codes

The parking lights on your vehicle will flash a specific number of times 3 seconds following an unscheduled shutdown. Each flashing pattern

is described below.

Flashes

Diagnostic

Runtime expired.

Over-rev shutdown.

Low or no RPM.

Shutdown without remote.

Brake shutdown.

Hood shutdown/Remote start safety override switch is ON.*

Remote start safety override switch is ON.*

* If the vehicle hood status is supported through data, the safety override switch input will report 7 flashes.

A module reset will only erase the steps perfomed in "Module Programming". The firmware and settings flashed to the module will not be

affected.

Connect the 10-pin & 12-pin harnesses to the module. Press and hold the programming

button, then connect the 14-pin harness to the module.

Wait 3 seconds until the LED turns ON solid orange then release the programming button.

The LED turns ON solid red.

Warning Against Executing a Hard Reset!

A hard reset will revert the flashed firmware back to its default factory settings. Depending on the installation, some settings may need to be

reconfigured. Connect your module to a computer and use the web configuration tool to edit its programmable features.

Connect the 10-pin & 12-pin harnesses to the module.

Press and hold the programming button, then connect the 14-pin harness to the

module.

Wait 3 seconds until the LED turns ON solid orange, and wait 10 more seconds until the

LED starts to flash orange and red.

Release the programming button. The LED turns ON solid red.

403.TL8 3.06 2020 Lexus GX 460 (Smart Key)

(Button)

(10-pin)

Solid

Release

(Button)

(10-pin)

Solid

Release

(12-pin)

(14-pin)

Solid

(12-pin)

(14-pin)

Flashes

Solid