Directed CHRYSLER4 Installation Manual - Page 9

Browse online or download pdf Installation Manual for Door locks Directed CHRYSLER4. Directed CHRYSLER4 16 pages. Door lock/convenience and override firmware for most chrysler, dodge and jeep.

Print Page
Directed CHRYSLER4 Installation Manual
Platform: DBALL2
Firmware:
CHRYSLER4

Module Programming

Refer to the
LED
Diagnostics section on page
Important
Make all the required connections to the vehicle, as described in the wiring diagram(s) found in this guide, and double check to
ensure everything is correct prior to moving onto the next step.
Warning!
To take advantage of advanced features, you must use Xpress
Flashing a module using your computer:
1. Connect the interface module to your computer using the
XKLoader2.
2. Go to www.directechs.com using Internet Explorer, and
select the
Flash Module
3. Follow the instructions to select your vehicle, installation
type, and configure your options.
4. Once you have configured the firmware options, click on the
FLASH button.
When the flashing operation is successful, you can proceed with the programming instructions below.
D2D Installation
If required for your installation, connect the 10-pin, 12-pin and 14-pin harnesses to
the module, then connect the 4-pin D2D harness.
OR
W W Installation
2
If required for your installation, connect the 10-pin and 12-pin harnesses to the
module, then connect the 14-pin harness to the module.
1
Wait until the LED turns
Insert
the key into the ignition barrel
2
the
LED
to flash orange.
Turn the key to the
flash orange. It will then turn
for 3 seconds, before turning
3
Refer to
the
LED
troubleshooting if the
orange within 15 seconds.
When the green
4
and
remove
it
from the ignition barrel.
You have successfully completed the module programming sequence.
n
for more information and for troubleshooting purposes.
button.
ON
solid red.
without turning it
ON
position. The
LED
will continue to
ON
solid green
OFF
.
Diagnostics section
on page
LED
does not turn
ON
LED
turns
OFF turn the key to the
,
VIP
4.5 (and higher) or the Directechs Mobile app.
Flashing a module using your smartphone or tablet
1. Connect the interface module to your
2. Launch the Directechs Mobile app on your smartphone or
tablet.
3. Select
FLASH YOUR MODULE
instructions.
th
4
st
1
st
1
and
wait
for
Key IN
OR
orange
10 for
solid green
OR
OFF
position
Rev.: 20170818
XKL
oader3.
and follow the on screen
rd
3
nd
2
rd
3
nd
2
Solid
Key IN
&
START
Flash Orange
or
&
START
Solid Green Solid Orange
&
Off
Key OUT
&
Off
© 2017 Directed. All rights reserved.
Page 9
START